Monitoring the float shrouds with rotating masts on initial rigging to ensure they do not become too tight or catch on anything during raising.
Winch operator should be careful to ensure that the trailer winch line lies evenly across drum while mast is beginning to be raised. With an offset bow roller, there can be a tendency for incoming line to pile up on one side of the drum to where it can suddenly slip off.

Mast raising and launching went without a hitch and within just over an hour we were taking our first sail, allowing the synthetic shrouds to stretch in. The 760 Sport comes standard with synthetic side shrouds and tensioning system from Colligo Marine

Here are a few pros and cons:

Roller Furling Pros:
Easily deployed
Easily stored
Easily reefed by partially furling sail
Can be managed from cockpit

Roller Furling Cons:
Mechanical parts that can fail
Hard to furl in strong wind
Poor lead in angle due to furling extrusion
Sail makes headstay bulky when furled
Weight aloft
Hard to change headsails
Hard to inspect headstay

Hank On Pros:
Less mechanical parts
Easy to lower sail in strong wind (simply release the halyard)
Ideal sail shape (this is why race boats have hank on headsails)
Minimal windage when sail is lowered
Sail can be removed for strong storms to further reduce windage
Minimal weight aloft
Easy to change headsails

Hank On Cons:
Sail must be flaked and stowed when lowered
Limited number of reefs available to be put in
Not as easy or quick to deploy
You have to go forward to tend to the sail
Cruising

You need to evaluate what you are looking for and what compromises you are willing to accept. As you can see, the both have pluses and minuses, it's just a matter of finding which you can live with.

Checking to see if all the halyard lines run from the mast through the turning blocks back to the correct rope clutches on the aft end of the cabin roof.

Because the bow must point directly or nearly into the wind to ease tension on the mainsail as it rises, the sailboat usually motors off the dock and into the wind in preparation for raising the main. At anchor or on a mooring, unless there is a strong counter-current, the bow will naturally face into the wind.

After ensuring the shackle is tight and the halyard clear to run up, loosen the mainsheet slightly while the boat maintains its orientation into the wind. Then start raising the main by hand.

Pointing ability is excellent but care must be taken not to over sheet or try to point too high. Just a few less pointing, with sheets slackened slightly, can see boat speed jump from 6 or 7 knots to 9 or 10 knots.

Corsair trimarans are sailed like any other yacht, the most notable differences being the response, lightness of the helm and the low angle of heel. This ranges from an average of 5° to 10° to a maximum of about 15°.